How to clean roller shutters from the inside, slat by slat
How to clean a roller shutter without taking it apart: dust it dry, wash it slat by slat, rinse and let it dry. Mistakes to avoid and real faults.
Written by Équipe WashMyGlass

Rather not do it yourself?
Shutter cleaning
From ₪100
The service exists: send a photo on WhatsApp and the price is confirmed in writing.
In Israel almost every window has a roller shutter, the tris. Dust, hamsin sand, salt near the sea and cobwebs build up between the slats. Every time the shutter goes up, it all falls on the glass and the sill: a window cleaned next to a dirty shutter looks dull again the next day.
The short answer: open the window, lower the shutter until the gaps between the slats open, vacuum the dust off dry, wipe each slat with a microfibre cloth dipped in warm soapy water, go over it again with a cloth in clean water and wait until the shutter is dry before rolling it up. No pressure washer, no bleach, and never force the motor of an electric shutter.
In short
- Dry first: a vacuum with a brush head, before any water.
- Top to bottom: drips land on the part you have not done yet.
- Washing-up liquid and warm water, no bleach and no scouring pad.
- Never roll up a wet shutter into its box.
- Shutter first, then its side channels, glass last.
- A shutter that comes down crooked or jams needs a shutter technician, not cleaning.
Which shutter do you have?
| Type | Where you find it | What to know |
|---|---|---|
| Manual roller shutter (with a strap) | Most flats in older buildings | Cleaned from inside through the open window; never yank the strap |
| Electric roller shutter | Newer flats, balcony doors | Same method, but stop the motor at a working height and keep the box dry |
| Sliding louvred shutter | Large glass doors, balconies, houses | Panels that slide on their own track: louvre by louvre, then the bottom track |
| Old plastic slats | Older buildings that never replaced them | Sun-dried plastic cracks easily: wipe without pressing |
What you need
- A vacuum cleaner with a brush head, or a soft dry brush
- Two buckets: one with warm water and a few drops of washing-up liquid, one with clean water
- Two or three microfibre cloths
- An old toothbrush for the side channels and corners
- An old towel on the sill to catch drips
Step by step: a roller shutter from the inside
1. Open the window and lower the shutter
In an Israeli flat the shutter sits outside the glass, in the same frame. Slide the window panel aside and lower the shutter until the gaps between the slats open. In that position you can see the slats and pass a cloth between them.
2. Vacuum dry
Run the brush head over the slats and along the side channels on both sides. Water on a thick layer of dust turns it into mud that smears and gets into the gaps.
3. Wash from top to bottom
Dip the microfibre in the soapy water and wring it out well: too wet, and it drips into the channels. Wrap a slat in the cloth and pull it along the full length, slat after slat, from the top down. When the cloth turns grey, rinse it and change the water.
4. Go over it with clean water
Soap left on the slats attracts dust. Wipe every slat with a damp cloth from the second bucket. Near the sea this is the step that matters: clean water is what lifts the salt.
5. Clean the shutter’s side channels
On each side of the window the shutter runs in narrow channels that fill with sand, leaves and insects. The toothbrush gets dirt out of the corners, then a damp cloth finishes the job. A shutter that is hard to roll up is not necessarily broken: often its channels are just full of sand.
6. Let it dry, roll it up, then do the glass
Leave the shutter down until the slats are dry to the touch. A shutter rolled up wet traps moisture in the box and dust sticks to the slats. Once it is dry, clean the glass: whatever fell off the shutter will not dirty a pane you have already done. For the glass itself: how to clean windows without streaks.
Electric shutters: what changes
- Use short presses and stop at the height you are working at. Holding the button down does not free a jammed shutter: it just strains the motor.
- Safety: before putting your hands between the slats, make sure nobody in the house will press the switch or the remote.
- Keep the box dry and do not pour water into the channels. A wrung-out cloth is enough.
- Do not open the box. The motor and roller are a job for a technician.
Sliding louvred shutters
On sliding aluminium panels, dust settles on the louvres and especially at the bottom of the panel. Clean each louvre with a soft brush and a damp cloth, without bending it. The bottom track the panel slides on fills with sand just like a window track: vacuum and wipe it before sliding the panel back and forth. Our guide to balcony glass, tracks and guards explains how to do tracks.
What about the outside of the shutter?
Through the gaps you can reach part of the outer face of the slats. Beyond that, only where it is safe: from the garden on the ground floor, or from a balcony the shutter opens onto. Never lean out of a window or stand on the sill to reach a shutter, even on the first floor. In the garden, a hose on low flow and a soft brush are enough; a pressure washer drives water into the box and the channels.
Mistakes to avoid
| Mistake | What happens | Do this instead |
|---|---|---|
| Pressure washer | Water in the box and motor, bent slats | Bucket, wrung-out cloth, low-flow hose in the garden |
| Bleach | Marks on the paint, weakened plastic and strap | Mild washing-up liquid |
| Oil in the channels to make it run smoother | Sand sticks and the channel clogs faster | Clean, dry channels |
| Rolling it up while still wet | Moisture in the box, dirt stuck to the slats | Wait until it is dry |
| Pulling hard on the strap | The strap wears and snaps | If it resists, check the channels first |
| Green scourer or steel wool | Scratches in the aluminium paint | Microfibre only |
Cleaning or a technician?
Cleaning brings back the shutter’s colour and stops dust falling on the glass. It does not fix a shutter that comes down crooked, a frayed strap, a broken slat or a motor that hums without moving: that needs a shutter technician. Worth checking before you call one: channels full of sand, the most common reason for a “heavy” shutter.
How often should you clean shutters?
There is no single number. Near the sea, salt builds up faster; near a road or a building site, dust does. Clean the shutters after a strong hamsin (see windows after a hamsin), before Pesach and whenever you give the windows a deep clean. To find the right rhythm: how often to clean windows in Israel.
When there are a lot of shutters
In a house with many shutters, tall electric shutters or glass doors with sliding shutters, the job becomes a project of its own. WashMyGlass cleans manual and electric roller shutters and aluminium shutters slat by slat, from ₪100, and can do them in the same visit as the windows. The box is not opened and the motor is not touched: any fault found is flagged for a technician. Send a photo of each type of shutter and how many there are on WhatsApp, and the price is confirmed in writing before the visit.
Frequently asked questions
Can I clean roller shutters with a pressure washer?
It is not recommended. The pressure drives water into the box, the motor and the channels, and can bend thin aluminium slats. A wrung-out cloth, a soft brush and, on the ground floor, a low-flow hose are enough.
What should I use on a greasy shutter near the kitchen?
Hotter water with a little more washing-up liquid, left on the slat for a moment before wiping, then a pass with clean water. Strong degreasers can mark old paint and plastic.
Do I need to take the shutter apart to clean it?
No. A roller shutter is cleaned in place, through the open window. Removing the shutter or opening the box is a job for a shutter technician.
How much does shutter cleaning cost?
At WashMyGlass, from ₪100. The final price depends on the number of shutters, their size, the type (manual or electric) and how dirty they are; it is fixed in writing from your photos, before the visit. All prices are on the price list.
Last updated ·
WhatsApp nowKeep this in mind before requesting a quote
A question about your situation?
Can the price be confirmed from photographs?+
Photographs create a first scope. The price is confirmed after surfaces, access and requested extras have been reviewed.
Are tracks and screens included?+
Mention them in the request: they are separate work from cleaning the glass itself.
Can I request a one-off visit?+
Yes. A one-off request can be prepared separately from a recurring service, depending on exposure and condition.
Send the photographs you have. We reply on WhatsApp to clarify scope and price before travel.
Continue reading
Continue reading
More useful topics for planning window cleaning in Israel.
Does your situation differ from this guide?
Describe it on WhatsApp and attach the useful photographs.
WhatsApp now


